The goods the subject of the application (the goods) are:

Certain utility scale wind towers, whether or not tapered, and sections thereof (whether exported assembled or unassembled), and whether or not including an embed being a tower foundation section.

Wind turbines that have electrical power generation capacities equal to or in excess of 1.00 megawatt (MW) and with a minimum height of 50 metres measured from the base of the tower to the bottom of the nacelle (i.e. where the top of the tower and nacelle are joined) when fully assembled.

The goods the subject of the application (the goods) are:

Steel Pallet racking, or parts thereof, assembled or unassembled, of dimensions that can be adjusted as required (with or without locking tabs and/or slots, and/or bolted or clamped connections), including any of the following - beams, uprights (up to 12m) and brace (with or without nuts and bolts).

Further information on the goods description can be found in ADN 2017/161

The goods the subject of the application (the goods) are:

Solid base angle, made from hot rolled coil steel, alloyed or non-alloyed, cold roll-formed, whether or not galvanised.

The subject goods are typically described as solid base angle or Budabar or B-bar or ribbed angle lintel or L-section and are typically used as lintels.

The goods are generally supplied in section sizes being nominally 100mm x 100mm x 6mm or 150mm x 100mm x 6mm ranging in length from 900mm to 4,000mm.

Goods Covered by the Investigation

Hot rolled rods in coils of steel, whether or not containing alloys, that have maximum cross sections that are less than 14mm.

The goods covered by this application include all steel rods meeting the above description regardless of the particular grade or alloy content.

Goods excluded from this application include hot-rolled deformed steel reinforcing bar in coil form, commonly identified as rebar or debar, and stainless steel in coils.

The goods the subject of the application (the goods) are:

Forged and rolled steel, high hardness, nominal 38-inch (or 966 mm to 970 mm) diameter, railway wheels, whether or not including alloys.

Axles and other components are excluded from the goods coverage.

Additional information

The railway wheels are manufactured in accordance with relevant user defined specifications and drawings, and are used on rail carriages used to transport iron ore. Further information on the goods is available in CON 466 (linked below).

The goods the subject of the application (the goods) are:

The goods the subject of the application (the goods) are:

Liquid dielectric power transformers with power ratings of equal to or greater than 10 MVA (mega volt amperes) and a voltage rating of less than 500kV (kilo volts) whether assembled or unassembled, complete or incomplete.